Freecom-technologies Storage Gateway NETWORK HARD DRIVE Manuel d'utilisateur télécharger pdf (Page 13)

Electrical requirements

Voltage: 100 - 240 V DC

Frequency: 50 - 60 Hz, single-phase

Environmental requirements

Operating temperature: 10 - 45° C (50 - 122° F)

Storage temperature: -10 - 70° C (-40 - 185° F)

Humidity: 20 - 80 % relative humidity, no condensation

Maximum operating altitude (above sea level): 3000 m (9900 ft)

Dimensions and weight

Dimensions: L x W x H: 17.5 x 14 x 4.4 cm / 6.9 x 5.5 x 1.7 inch

Weight: 950 g

Chapter 1: Connecting / Installing FSG

1.1 Hardware Installation

Setup of the FSG is performed using the following steps:

1. Plug the FSG's power cord into a power outlet.

2. Switch on DHCP on the PC, a DHCP server is automatically on on the FSG

3. Connect the included Ethernet Cable into the Ethernet port on the rear of FSG into

one of the LAN ports (1,2 or 3). Connect the other end of the cable directly to the PC.

4. Check the LINK/ACT light on the UTP port you have connected on the FSG-3. If it is

lit, then your FSG is connected properly.

Connecting / Installing FSG

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 128 129

Pas de commentaire

Freecom-technologies Storage Gateway NETWORK HARD DRIVE Manuel d'utilisateur Page 13