Freecom-technologies Hard Drive Secure Manuel d'utilisateur télécharger pdf (Page 7)

Hardware Installation

Chapter 1: Hardware Installation

Remove the plastic protective cover sheets from the front and rear of the drive. Before

connecting the cables make sure the Freecom Hard Drive Secure is switched off.

1. Connect the interface cable (USB) to the Freecom Hard Drive

Secure.

2. Connect the cable of the power supply to the Freecom

Hard Drive Secure and the power supply itself to the mains

socket.

3. Connect the interface cable (USB) to the interface port (USB)

of your computer.

4. Switch on the Freecom Hard Drive Secure.

Since USB 2.0 is backwards compatible with USB 1.1, the Freecom Hard Drive

Secure can be connected to all USB ports. When connected to a USB 1.1 port,

however, the performance (data transfer rate) of the Freecom Hard Drive Secure

will be much lower than when the drive is connected to a USB 2.0 port.

For optimum performance the Freecom Hard Drive Secure should always be

connected to a USB 2.0 interface.

1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

Pas de commentaire

Freecom-technologies Hard Drive Secure Manuel d'utilisateur Page 7